Vandal Cover Instructions
Step 1
Using supplied plastic (putty knife) or similar, carefully pry open the bottom hinged frame section as shown, exposing the hidden set screws.
![message board vandal cover](https://www.ezsignsonline.com/wp-content/uploads/2020/05/vandal-cover-lock-1.jpg)
![message board vandal cover](https://www.ezsignsonline.com/wp-content/uploads/2020/05/vandal-cover-lock-3.jpg)
Step 2
Using the handheld allen wrench tool, unscrew the set screws as shown. You may have 2-4 screws depending on the size of your vandal cover.
![Vandal Cover message board vandal cover](https://www.ezsignsonline.com/wp-content/uploads/2020/05/vandal-cover-lock-4.jpg)
Step 3
You then place the prop sticks in the corners of your opened vandal cover frame to gain access to the message board.
![message board vandal cover](https://www.ezsignsonline.com/wp-content/uploads/2020/05/vandal-cover-in-open-position-2.jpg)
![message board vandal cover](https://www.ezsignsonline.com/wp-content/uploads/2020/05/vandal-cover-prop.jpg)